* G28 - X0 Y0 Z0 Home all Axis. G28 M for bed manual setting with LCD.
* G29 - Detailed Z-Probe, probes the bed at 3 points or grid. You must be at the home position for this to work correctly.
G29 Fyyy Lxxx Rxxx Byyy for customer grid.
* G30 - Single Z Probe, probes bed at current XY location.
Bed Probe and Delta geometry Autocalibration G30 A
* G30 - Single Z Probe, probes bed at current XY location. Bed Probe and Delta geometry Autocalibration G30 A
* G31 - Dock Z Probe sled (if enabled)
* G32 - Undock Z Probe sled (if enabled)
* G60 - Save current position coordinates (all axes, for active extruder). S<SLOT> - specifies memory slot # (0-based) to save into (default 0).
...
...
@@ -60,7 +59,7 @@
* M109 - S[xxx] Wait for extruder current temp to reach target temp. Waits only when heating - R[xxx] Wait for extruder current temp to reach target temp. Waits when heating and cooling
* M111 - Debug Dryrun Repetier
* M112 - Emergency stop
* M114 - Output current position to serial port, (V)erbose for user
*M114 - Output current position to serial port, (V)erbose for user
* M115 - Capabilities string
* M117 - display message
* M119 - Output Endstop status to serial port
...
...
@@ -100,8 +99,8 @@
* M405 - Turn on Filament Sensor extrusion control. Optional D[delay in cm] to set delay in centimeters between sensor and extruder
* M406 - Turn off Filament Sensor extrusion control
* M407 - Displays measured filament diameter
* M410 - Quickstop. Abort all the planned moves
* M428 - Set the home_offset logically based on the current_position
*M410 - Quickstop. Abort all the planned moves
*M428 - Set the home_offset logically based on the current_position
* M500 - stores paramters in EEPROM
* M501 - reads parameters from EEPROM (if you need reset them after you changed them temporarily).
* M502 - reverts to the default "factory settings". You still need to store them in EEPROM afterwards if you want to.
