Fix Configuration COREXY

MarlinKimbra/Configuration_Corexy.h

@@ -120,13 +120,6 @@ const bool Z_MAX_ENDSTOP_INVERTING = false; // set to true to invert the logic o
 // and least squares solution is calculated
 // Note: this feature occupies 10'206 byte
 #ifdef AUTO_BED_LEVELING_GRID
-
-// set the rectangle in which to probe
-#define LEFT_PROBE_BED_POSITION 15
-#define RIGHT_PROBE_BED_POSITION 170
-#define BACK_PROBE_BED_POSITION 180
-#define FRONT_PROBE_BED_POSITION 20
-
 // set the number of grid points per dimension
 // I wouldn't see a reason to go above 3 (=9 probing points on the bed)
 #define AUTO_BED_LEVELING_GRID_POINTS 2
@@ -147,17 +140,15 @@ const bool Z_MAX_ENDSTOP_INVERTING = false; // set to true to invert the logic o
 
 
 // these are the offsets to the probe relative to the extruder tip (Hotend - Probe)
-#define X_PROBE_OFFSET_FROM_EXTRUDER -25
-#define Y_PROBE_OFFSET_FROM_EXTRUDER -29
-#define Z_PROBE_OFFSET_FROM_EXTRUDER -12.35
+#define X_PROBE_OFFSET_FROM_EXTRUDER 0
+#define Y_PROBE_OFFSET_FROM_EXTRUDER 20
+#define Z_PROBE_OFFSET_FROM_EXTRUDER -3.10
 
-#define Z_RAISE_BEFORE_HOMING 4       // (in mm) Raise Z before homing (G28) for Probe Clearance.
+#define Z_RAISE_BEFORE_HOMING 10       // (in mm) Raise Z before homing (G28) for Probe Clearance.
 // Be sure you have this distance over your Z_MAX_POS in case
 
-#define XY_TRAVEL_SPEED 8000         // X and Y axis travel speed between probes, in mm/min
-
-#define Z_RAISE_BEFORE_PROBING 15    //How much the extruder will be raised before traveling to the first probing point.
-#define Z_RAISE_BETWEEN_PROBINGS 5  //How much the extruder will be raised when traveling from between next probing points
+#define Z_RAISE_BEFORE_PROBING 10    //How much the extruder will be raised before traveling to the first probing point.
+#define Z_RAISE_BETWEEN_PROBINGS 5   //How much the extruder will be raised when traveling from between next probing points
 
 //#define Z_PROBE_SLED // turn on if you have a z-probe mounted on a sled like those designed by Charles Bell
 //#define SLED_DOCKING_OFFSET 5 // the extra distance the X axis must travel to pickup the sled. 0 should be fine but you can push it further if you'd like.