Add right configs

MK/Configuration_Feature.h

@@ -1213,9 +1213,9 @@
  ************************** Motor's current ****************************
  ***********************************************************************/
 // Motor Current setting (Only functional on ALLIGATOR BOARD)
-#define MOTOR_CURRENT {1, 1, 1, 1, 1, 1, 1} // X Y Z E0 E1 E2 E3 - Values 0 - 2.5 A
+#define MOTOR_CURRENT {1.0, 1.0, 1.0, 1.0, 1.0, 1.0, 1.0} // X Y Z E0 E1 E2 E3 - Values 0 - 2.5 A
 // Motor Current setting (Only functional when motor driver current ref pins are connected to a digital trimpot on supported boards)
-#define DIGIPOT_MOTOR_CURRENT {135,135,135,135,135} // Values 0-255 (RAMBO 135 = ~0.75A, 185 = ~1A)
+#define DIGIPOT_MOTOR_CURRENT {135, 135, 135, 135, 135} // Values 0-255 (RAMBO 135 = ~0.75A, 185 = ~1A)
 /***********************************************************************/
 
 

MK/Configuration_Pins.h

@@ -70,7 +70,7 @@
 #define HEATER_3_PIN        ORIG_HEATER_3_PIN
 #define HEATER_BED_PIN      ORIG_HEATER_BED_PIN
 #define HEATER_CHAMBER_PIN  -1
-#define COOLER_PIN          -1
+#define COOLER_PIN          2
 
 // TEMP pin
 #define TEMP_0_PIN        ORIG_TEMP_0_PIN
@@ -108,11 +108,16 @@
 #endif
 
 #if ENABLED(LASERBEAM)
-  #define LASER_PWR_PIN                   -1
-  #define LASER_TTL_PIN                   -1
+  #if LASER_CONTROL == 1
+    #define LASER_PWR_PIN    5
+    #define LASER_TTL_PIN -1
+  #elif LASER_CONTROL == 2
+    #define LASER_PWR_PIN 6
+    #define LASER_TTL_PIN 5
+  #endif
   #if ENABLED(LASER_PERIPHERALS)
-    #define LASER_PERIPHERALS_PIN         -1
-    #define LASER_PERIPHERALS_STATUS_PIN  -1
+    #define LASER_PERIPHERALS_PIN         11
+    #define LASER_PERIPHERALS_STATUS_PIN  14
   #endif
 #endif
 
@@ -125,7 +130,7 @@
 #endif
 
 #if ENABLED(FLOWMETER_SENSOR)
-  #define FLOWMETER_PIN -1
+  #define FLOWMETER_PIN 21
 #endif
 
 #if ENABLED(POWER_CONSUMPTION)

MK/Configuration_Temperature.h

@@ -73,7 +73,7 @@
 #define TEMP_SENSOR_2 0
 #define TEMP_SENSOR_3 0
 #define TEMP_SENSOR_BED 0
-#define TEMP_SENSOR_CHAMBER 0
+#define TEMP_SENSOR_CHAMBER 0 // NOT USED FOR NOW!!!
 #define TEMP_SENSOR_COOLER 40
 
 //These 2 defines help to calibrate the AD595 sensor in case you get wrong temperature measurements.