Merge branch 'master' into k40_noflow_nocooler

MK/module/boards/301.h

@@ -74,17 +74,25 @@
 #define KILL_PIN           -1 // 80 with Smart Controller LCD
 #define SUICIDE_PIN        -1 // PIN that has to be turned on right after start, to keep power flowing.
 
-#undef LASER_INTENSITY_PIN
-#undef LASER_FIRING_PIN
+#undef LASER_TTL_PIN
+#undef LASER_PWR_PIN
 #if LASER_CONTROL == 1
-   #define LASER_FIRING_PIN    5
-   #define LASER_INTENSITY_PIN -1
+   #define LASER_PWR_PIN    5
+   #define LASER_TTL_PIN -1
 #endif
 #if LASER_CONTROL == 2
-   #define LASER_INTENSITY_PIN 5 // Digital pins 2, 3, 5, 6, 7, 8 are attached to timers we can use
-   #define LASER_FIRING_PIN   2
+   #define LASER_TTL_PIN 5 // Digital pins 2, 3, 5, 6, 7, 8 are attached to timers we can use
+   #define LASER_PWR_PIN   2
 #endif
 
+#if ENABLED(LASER_PERIPHERALS)
+   #undef LASER_PERIPHERALS_PIN
+   #undef LASER_PERIPHERALS_STATUS_PIN
+   #define LASER_PERIPHERALS_PIN       11
+   #define LASER_PERIPHERALS_STATUS_PIN      4
+#endif
+
+
 
 #if ENABLED(ULTRA_LCD)
   #define KILL_PIN 80

MK/module/boards/33.h

@@ -70,6 +70,37 @@
 #define ORIG_HEATER_BED_PIN     8   // BED
 #define ORIG_TEMP_BED_PIN       14  // ANALOG NUMBERING
 
+
+#if ENABLED(LASERBEAM)
+	#undef LASER_TTL_PIN
+	#undef LASER_PWR_PIN
+	#if LASER_CONTROL == 1
+  		#define LASER_PWR_PIN    5
+  		#define LASER_TTL_PIN -1
+	#endif
+	#if LASER_CONTROL == 2
+   	#define LASER_TTL_PIN 6 // Digital pins 2, 3, 5, 6, 7, 8 are attached to timers we can use
+   	#define LASER_PWR_PIN  5 
+	#endif
+#endif
+#if ENABLED(LASER_PERIPHERALS)
+   #undef LASER_PERIPHERALS_PIN
+   #undef LASER_PERIPHERALS_STATUS_PIN
+   #define LASER_PERIPHERALS_PIN       11
+   #define LASER_PERIPHERALS_STATUS_PIN      4
+#endif
+
+#if ENABLED(PIDTEMPCOOLER)
+   #undef COOLER_PIN
+	#define COOLER_PIN 2
+#endif
+
+#if ENABLED(FLOWMETER_SENSOR)
+  #undef FLOWMETER_PIN
+  #define FLOWMETER_PIN 21
+#endif
+
+
 #if ENABLED(REPRAP_DISCOUNT_SMART_CONTROLLER) || ENABLED(G3D_PANEL)
   #define KILL_PIN              41
 #else