Water cooling pin maps

MK/Configuration_Laser.h

@@ -19,6 +19,8 @@
 
 // Uncomment the following to enable the use of the PWM (the one for the extruder 0) to drive a peltier cell or any PWM driven cooler for the laser
 #define LASER_WATER_COOLING
+#define LASER_WATER_MAXTEMP 25
+
 
 //// The following defines select which G codes tell the laser to fire.  It's OK to uncomment more than one.
 #define LASER_FIRE_G1 10 // fire the laser on a G1 move, extinguish when the move ends

MK/Configuration_Pins.h

@@ -114,16 +114,20 @@
       #define LASER_INTENSITY_PIN 6 // Digital pins 2, 3, 5, 6, 7, 8 are attached to timers we can use
       #define LASER_FIRING_PIN   5
    #endif
-   #ifdef LASER_POWER_DOWN
+   #if ENABLED(LASER_POWER_DOWN)
       #define LASER_POWER_PIN 9 // This is currently hard-coded to timer2 which services pins 9, 10
    #endif // LASER_POWER_DOWN
-   #ifdef LASER_PERIPHERALS
-      #define LASER_PERIPHERALS_PIN       4
-      #define LASER_PERIPHERALS_STATUS_PIN      11
+   #if ENABLED(LASER_PERIPHERALS)
+      #define LASER_PERIPHERALS_PIN       11
+      #define LASER_PERIPHERALS_STATUS_PIN      32
    #endif // LASER_PERIPHERALS
-
+   #if ENABLED(LASER_WATER_COOLING)
+      #define LASER_WATER_COOLING_PIN 4
+   #endif
 #endif
 
+
+
 #if ENABLED(FILAMENT_RUNOUT_SENSOR)
   #define FILRUNOUT_PIN -1
 #endif

MK/base.h

@@ -34,6 +34,14 @@
 #include "Configuration_Feature.h"
 #include "Configuration_Overall.h"
 
+#if ENABLED(LASER)
+  #include "Configuration_Laser.h"
+  #if ENABLED(LASER_RASTER)
+    #include "module/base64/Base64.h"
+  #endif
+  #include "module/laser/laser.h"
+#endif
+
 #include "module/conditionals.h"
 #include "module/sanitycheck.h"
 #include "module/HAL/HAL.h"
@@ -75,12 +83,4 @@
   #include "module/mfrc522/MFRC522_serial.h"
 #endif
 
-#if ENABLED(LASER)
-  #include "Configuration_Laser.h"
-  #if ENABLED(LASER_RASTER)
-    #include "module/base64/Base64.h"
-  #endif
-  #include "module/laser/laser.h"
-#endif
-
 #endif