* Only change these if you know exactly what you're doing.
* Some of these settings can damage your printer if improperly set!
*
* Basic settings can be found in Configuration.h
*
*/
#ifndef CONFIGURATION_ADV_H
#define CONFIGURATION_ADV_H
...
...
@@ -295,14 +305,21 @@
//#define CHDK 4 //Pin for triggering CHDK to take a picture see how to use it here http://captain-slow.dk/2014/03/09/3d-printing-timelapses/
#define CHDK_DELAY 50 //How long in ms the pin should stay HIGH before going LOW again
#define SD_FINISHED_STEPPERRELEASE true //if sd support and the file is finished: disable steppers?
#define SD_FINISHED_RELEASECOMMAND "M84 X Y Z E" // You might want to keep the z enabled so your bed stays in place.
#ifdef SDSUPPORT
// Disable steppers when the file is done printing?
#define SD_FINISHED_STEPPERRELEASE true
// Command to send. You may want to keep Z enabled so your bed stays in place.
#define SD_FINISHED_RELEASECOMMAND "M84 X Y Z E"
#define SDCARD_RATHERRECENTFIRST //reverse file order of sd card menu display. Its sorted practically after the file system block order.
// if a file is deleted, it frees a block. hence, the order is not purely chronological. To still have auto0.g accessible, there is again the option to do that.
// using:
// Reverse file order of sd card menu display. It's sorted practically after the file system block order.
// When a file is deleted it frees a block, so the order is not purely chronological.
#define SDCARD_RATHERRECENTFIRST
// To still have auto0.g accessible, there is again the option to do that. Using:
//#define MENU_ADDAUTOSTART
#endif // SDSUPPORT
// The hardware watchdog should reset the microcontroller disabling all outputs, in case the firmware gets stuck and doesn't do temperature regulation.
