Update

MarlinKimbra/pins.h

@@ -2026,7 +2026,7 @@
 /* On some broken versions of the Sanguino libraries the pin definitions are wrong, which then needs SDSS as pin 24. But you better upgrade your Sanguino libraries! See #368. */
 //#define SDSS               24
 
- #ifdef ULTRA_LCD
+#ifdef ULTRA_LCD
   #ifdef NEWPANEL
     //we have no buzzer installed
     #define BEEPER -1
@@ -2076,9 +2076,9 @@
     #define SDCARDDETECT -1
 
   #endif //Newpanel
- #endif //Ultipanel
+#endif //ULTRA_LCD
 
- #ifdef MAKRPANEL
+#ifdef MAKRPANEL
   #define BEEPER 29
   // Pins for DOGM SPI LCD Support
   #define DOGLCD_A0  30
@@ -2097,7 +2097,7 @@
   #define BTN_ENC 16  //the click switch
   //not connected to a pin
   #define SDCARDDETECT -1
- #endif //Makrpanel
+#endif //Makrpanel
 
 #endif // SANGUINOLOLU_11
 /****************************************************************************************/

MarlinKimbra/stepper.cpp

@@ -596,10 +596,10 @@ ISR(TIMER1_COMPA_vect) {
         #endif
 
         #define STEP_IF_COUNTER(axis, AXIS) \
-          if (counter_## axis > 0) {
+          if (counter_## axis > 0) { \
             counter_## axis -= current_block->step_event_count; \
             count_position[AXIS ##_AXIS] += count_direction[AXIS ##_AXIS]; \
-            AXIS ##_STEP_WRITE(LOW);
+            AXIS ##_STEP_WRITE(LOW); \
           }
 
         STEP_IF_COUNTER(x, X);
@@ -711,7 +711,7 @@ ISR(TIMER1_COMPA_vect) {
     // Set E direction (Depends on E direction + advance)
     for(unsigned char i=0; i<4;i++) {
       if (e_steps[0] != 0) {
-        E0_STEP_WRITE( INVERT_E_STEP_PIN);
+        E0_STEP_WRITE(INVERT_E_STEP_PIN);
         if (e_steps[0] < 0) {
           E0_DIR_WRITE(INVERT_E0_DIR);
           e_steps[0]++;
@@ -786,7 +786,6 @@ void st_init() {
     L6470_init();
   #endif
   
-  
   // Initialize Dir Pins
   #if defined(X_DIR_PIN) && X_DIR_PIN >= 0
     X_DIR_INIT;