Add DISABLE_M503

MarlinKimbra/Configuration.h

@@ -527,9 +527,10 @@ your extruder heater takes 2 minutes to hit the target on heating.
 // M502 - reverts to the default "factory settings".  You still need to store them in EEPROM afterwards if you want to.
 //define this to enable EEPROM support
 //#define EEPROM_SETTINGS
+#define EEPROM_CHITCHAT
 // to disable EEPROM Serial responses and decrease program space by ~1700 byte: comment this out:
 // please keep turned on if you can.
-#define EEPROM_CHITCHAT
+//#define DISABLE_M503
 
 //========================= Bowden Filament management ======================
 //#define EASY_LOAD

MarlinKimbra/ConfigurationStore.cpp

@@ -380,7 +380,7 @@ void Config_ResetDefault()
   SERIAL_ECHOLNPGM("Hardcoded Default Settings Loaded");
 }
 
-#ifdef EEPROM_CHITCHAT
+#ifndef DISABLE_M503
   void Config_PrintSettings()
   {  // Always have this function, even with EEPROM_SETTINGS disabled, the current values will be shown
     SERIAL_ECHO_START;
@@ -604,4 +604,4 @@ void Config_ResetDefault()
       }
     #endif //FWRETRACT
   }
-#endif //EEPROM_CHITCHAT
+#endif //!DISABLE_M503

MarlinKimbra/ConfigurationStore.h

@@ -6,17 +6,17 @@
 void Config_ResetDefault();
 
 #ifndef DISABLE_M503
-void Config_PrintSettings();
+  void Config_PrintSettings();
 #else
-FORCE_INLINE void Config_PrintSettings() {}
+  FORCE_INLINE void Config_PrintSettings() {}
 #endif
 
 #ifdef EEPROM_SETTINGS
-void Config_StoreSettings();
-void Config_RetrieveSettings();
+  void Config_StoreSettings();
+  void Config_RetrieveSettings();
 #else
-FORCE_INLINE void Config_StoreSettings() {}
-FORCE_INLINE void Config_RetrieveSettings() { Config_ResetDefault(); Config_PrintSettings(); }
+  FORCE_INLINE void Config_StoreSettings() {}
+  FORCE_INLINE void Config_RetrieveSettings() { Config_ResetDefault(); Config_PrintSettings(); }
 #endif
 
-#endif//CONFIG_STORE_H
+#endif //CONFIG_STORE_H