/**
 * MK & MK4due 3D Printer Firmware
 *
 * Based on Marlin, Sprinter and grbl
 * Copyright (C) 2011 Camiel Gubbels / Erik van der Zalm
 * Copyright (C) 2013 - 2016 Alberto Cotronei @MagoKimbra
 *
 * This program is free software: you can redistribute it and/or modify
 * it under the terms of the GNU General Public License as published by
 * the Free Software Foundation, either version 3 of the License, or
 * (at your option) any later version.
 *
 * This program is distributed in the hope that it will be useful,
 * but WITHOUT ANY WARRANTY; without even the implied warranty of
 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
 * GNU General Public License for more details.
 *
 * You should have received a copy of the GNU General Public License
 * along with this program. If not, see <http://www.gnu.org/licenses/>.
 *
 */

/**
 * flowmeter.h - Flowmeter control library for Arduino - Version 1
 * Copyright (c) 2016 Franco (nextime) Lanza.  All right reserved.
 *
 * This library is free software; you can redistribute it and/or
 * modify it under the terms of the GNU Lesser General Public
 * License as published by the Free Software Foundation; either
 * version 3 of the License, or (at your option) any later version.
 *
 * This library is distributed in the hope that it will be useful,
 * but WITHOUT ANY WARRANTY; without even the implied warranty of
 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU
 * Lesser General Public License for more details.
 *
 * You should have received a copy of the GNU Lesser General Public
 * License along with this library; if not, write to the Free Software
 * Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA  02110-1301  USA
 */

#ifndef FLOWMETER_H
  #define FLOWMETER_H

  #define FLOWMETER_CALIBRATION (FLOWMETER_MAXFREQ / FLOWMETER_MAXFLOW)

  #if ENABLED(FLOWMETER_SENSOR)
  void flowrate_manage();
  void flow_init();
  float get_flowrate();
  #endif

#endif // FLOWMETER_H
